Products

Primary Products

InCon Major Parts and Part Numbering

CTC-6 and CTC-12 are Communication Termination Cabinets for 6 or 12 locations InCon Faceplates

The part numbers are: DW00 and TW00.

The “D” for Duo-Plate

location or 2 types of

services, Cable and

Twisted Pair, while the

“T” for Tri-Plate location

which services 3 types of

services, Cable, Twisted

Pair and Power. The

“W” in the part number denotes the color White.

The “00” is the amount of wire connected to the plate.

This allows for easy Part number identification of Pre-Wired Plates

InCon Communication Wire is part Numbered: “DC” as in Dual types of available for simple individual

communication wire. These are the 2 types that are drops. These are mainly used

most recommended for a premium Home communication in Factory built homes and

system: RG-6 COAX and “DC-Reel” is the part number some retro-fit applications.

for the 1,000 ft. reel shown here. These pre-wired plates can

also be directly connected to a

CTC located in the same

The two types of wires are individually jacketed and section of the home.

Are thinly webbed together to simplify handeling as well as the

installation process. This also assures that all

InCon locations have all the same capabilities.

The 2 components are easily separated for easy

termination and connection to incoming services.

Temporary Cover Plates (TMP) are for when Tri-Plates are to be used. These temporary cover plates are used at rough in to hold the DuoCon communication wire in place next to the AC wire single size electrical enclosure (box). Affixing these covers, with the screws provided, will protect the electrical wire in the box as well as provide a cut out template when putting up the wall board. These should not be removed until trimming out and putting on the Tri-Plates.

Front View Rear View

Pre-wired lengths of InCon’s DuoCon wire are available for the factory built structures. These are simply numbered with a “P” for pre-wired a number to indicate the number of feet and an “M” to indicate one end has the mating connectors already installed and tested. The 30 foot pre-wire shown in the picture to the left would be part numbered

P30M.

If the pre-wire is to bridge across a section it would have an MM to indicate a mating set of connections at each end.

These pre-wires can be wired to the CTC and run to the cross over point or wired to the InCon faceplate and pulled to the cross over point. At that point InCon’s DuoCon Splice hardware kit can make the connection when the sections of the home are set. Seen above is a DC-SPLICE.